Guide: How to make your own Pen Cannon
Well, I was bored, and I had some extra fireworks laying around, what better to do than make a cannon!!!!
Ok, here are the materials you need:
Pen that you can fit a tack in (preferably see through)
Sharp hin knife
Take your pen, and make it empty, take out all the ink stuff. Now take whatever your using for a plug, and make it so about 1/2 an inch will fit in one end of your pen. Make sure it is a TIGHT seal. or else the plug will fly out, not your "bullet".
Take your pen and check if a tack, or basiclly anything else fits in it, snugly. And near the end of the pen where you put the plug in, make a fuse holee
First if you have a firework, cut off the fuse, next, somehow loosen up the gunpowder inside, and pour SOME into the pen, so a fair amount rests at the end with the plug. DONT OVER POWER IT!!!!
Now put the fuse in, and make sure it has contact with you gunpowder. Insert your tack, or "bullet" and make sure it does NOT, NOT NOT NOT, get stuck tight, if it gets stuck tight, all of your power will exert out of the fuse hole, yes this happend to me on my second try.
Well there ya go, i suggest either going outside, or in your bathtub. It works like charm, careful not to burn yoourself. And happy Blowing!!!!