I have been currently switching between VGA box and my monitor undecided as to have poor resolution and colour through the VGA box or use my VGA cable and have slightly higher resolution (although every couple of minutes the monitor goes off for about half a second which is annoying). This morning my VGA box broke and now I am stuck at the second option. Unfortunately my monitor only works with 560P with anything else I get a "Mode not supported" on my monitor. So It would be geat if someone could guide me to the 560P check box on the composite output. I will be starting from the top left of the XMB.
I am on FW 2.35 in case any new menu items have been added.
Hold down left to get to far left.
Hold up to go to the top.
Press right once to get to the settings menu.
What steps are after this?