Here is a little guide, showing how the Deep Mind preset was converted across.
Take a look at that image, upon opening BWG select the preset you want to change across, then click the button to the left of the list(preset options). Section A in the jpeg will appear. At position A2 is the list of 'voices' in the preset. The first one in the list should be selected, click on the sound tab at position A1 and the sound screen in B will appear. Here is where we will get our values for the preset file.
The first value we need is the begining frequency at position B4. Click on the small box that is circled and then note down the number that will appear just above the second graph under 'audible pitch'. The text you should see is 300hz, 0.0min. Now to finish our first binaural beat. Click on the first small box at location B3, you should see the text '14.1hz, 0.0min'. We can now setup our first voice.
Open notepad, and type in a name for the preset. For this example it will be 'Deep Mind'. Next we setup our first voice, by using the following preset parameter:
V(frequency) (binaural offset)
In the first field we put our base frequency(300), and in the second we put our binaural beat(14.1). These two frequencies are used to create a binaural beat by providing one frequency to one ear(300hz) and the binaural beat to the other(314.1hz). That's it, our first voice has been created! This is what you should have:
Now on to the timers. In the graph at position B3 you will see that the boxes gradually change as the pitch is changed over time. If you click on the box at B3 you should see the text '14.1hz, 0.67min'. This is where the first change starts, note down the two numbers. Now click on the next box a little further along the graph. You should see the text '10hz, 2.0min' appear. We now have enough to add our first timer.
First of all we need to work out how long in seconds the first timer is using a bit of simple math(60/100*67) which comes to just over 40 seconds. Now for the second timer, (2*60) which comes to 120 seconds. Now to setup the timer with the following preference:
T(voice #0-7) (begin time(secs)) (end time(secs)) (base hz target) (binaural hz target)
Entering the numbers gathered you should have the following:
T0 40 120 300.0 10
You now need to go through the rest of the boxes, and follow the methods above until you've gone through them all. You also need to repeat this for all of the voices in the first screen. Thankfully the deep mind preset only uses 5 timers in total.
Here is the file you should have in the end after following these instructions through for the entire preset:
T0 40 120 300.0 10
T0 240 360 300 7.8
T0 690 760 300 5.5
T0 880 960 300 4.0
T0 1360 1800 300 3.5
Note that we have 4 voices setup, and then 4 with 0 as the frequency. We have a total of 8 voices(16 channels) available to us, but if we don't use them all then just set the frequencies to 0 to disable the channel.
I hope this 'small' guide is of help to you, if you're unsure about anything mentioned in it feel free to ask me either on here, or on the forums :)