ytd i just used moose_island's guide to mod my friend's fat psp. it was successful all thanks to moose_island's guide. anw now i am planning to mod psp slims for other ppl. but before i brick someone's psp slim. i just wanna know whether wad i am doing is correct. by using the second guide, i successfully made a pandora batt and mem stick. of which i used to mod my friends fat psp.
1)would i be able to use the same batt and mem stick to help mod other ppl's psp slim?
2)would the display be the same? or it would be a blank where i have to blindly press. (if the display is same move to qn4, if not qn3)
3)would the first screen that load up after i put in the mem stick first then the batt be the ultimate loader thing or it will be the screen where it says "press X to install 3.71m33"?
4)how long will the batt last. for example i bring out 1 batt. how many psp slims can i mod b4 the batt runs out.
5) will the psp slim brick if the batt suddenly died?
6) i read guides where they said batt must be at least 70%. wad if my batt was 100% when i started and dropped to below 70%. does that mean that the psp slim will brick?
7) how do i check how much batt is left? plug in AC adapter on the psp and then put in the batt?
8)if the batt is low is there any way to continue modding, for example put in the mem stick. then the batt. then while it is flashing i plug in the ac adapter to make sure it dun use much batt?
thx for answering my qns!